Semi-Automatic Labeling Machine with Coder T30114

Remarks

• Labeling accurate, high stability, adopt PLS + Stepper motor driver to conveyor labels, more accurate; mechanism for material with brake function to sure label belt is tight, and sure label testing accurate; label road have check and correct mechanism to avoid label run to right or left
• long life and Durability, electric road apart with air road, setting up decontamination plant on air road avoid drop into electric equipment, to expanding product’s life. Whole equipment under high grade stainless steel and aluminum alloy, it’s strong
• Adjustment convenient, have function of adjustable stroke, no need to change the relevant management tool for different height of product.
• Attractive looking, adopt computer electric box set up bottom, match material of stainless steel and aluminium ally to improve product’ grade.
• Having manual/automatic 2 method to control labeling, worker can select to use sensor or food stepping the control labeling when they face to different circumference. There are accordingly button of manual or automatic controller, and label length could be debugging as per requirement.

Precautions

1. Be sure to use it with a grounding wire to prevent electric shock.

2. Make sure that the voltage is not overloaded.

3. the electric box part, the line part must be operated under the guidance of an electrician or a professional.

4. the rotating parts need special attention to prevent crushing.

5. The following environments are not suitable for application:

• Places where temperature changes are fierce
• Where the humidity is too high and dew is generated
• Places where vibration or shock is strong.
• Places with a lot of dust.
• Where water, oil, and chemicals splash.
• Places with explosive and flammable dangerous goods

Common problem

Break mark

The pressure of the synchronous belt pulley is too large – relax the adjusting nut

The pick-up timing pulley is stuck – add a washer on the timing pulley

The label disc brake pressure is too high – relax the brake spring

Pressure gauge spring steel sheet pressure is too large – loosen the set screw to reduce pressure

Label bottom paper edge wear – replace the label or adjust the guide rod positioning ring

The label backing paper is too thin or has a die cut mark – replace the label

Label peeling plate angle is not good – adjust to the appropriate position

No label or continuous missing

Electric eye setting error – reset the electric eye

Low sensitivity of the electric eye – re-adjust the electric eye to improve sensitivity

Wrinkle mark

Pressure plate pressure is too large – adjust the platen to the appropriate position

Tip sponge is not flat – replace the tip sponge

The label speed is too slow – adjust the label speed

The surface of the object is too curved – this machine is not suitable

Oblique mark

Stripping plate is not correct – adjust the stripping plate to the appropriate position

Labels are not on the same level – adjust the label locating ring or target

Traction speed too fast – reduce traction speed

Blowing pipe is too large – adjusting the pressure regulating valve

Difficulty in sucking

Suction is too small – adjust the pressure regulating valve

The label is too small – blocking excess suction

Blowing pipe angle is not right – adjust the blowing pipe angle

The distance between the tip and the stripping plate is too far away – adjust the distance between the tip and the stripping plate