Series Bucket Vibrating Screw Feeder HZF-S2

Remarks

• During feeder operation, pay attention to the material level in the storage bin. If the bin is already full and the feeder continues to supply material, it may cause blockage at the outlet of the feeding pipe, damage the spiral blades, and even result in motor burnout. (It is strictly prohibited to continue operating the feeder in the event of a blocked outlet of the feeding pipe.)

• If there is a blockage or obstruction in the feeding process, immediately stop the
  operation. Open the discharge gate, reverse the feeding motor, and remove the
  material or debris that is blocking the feeding pipe. Clean the feeding pipe.

• If any abnormal sound occurs in the feeding pipe during operation, stop immediately, cut off the power supply, lay the feeding pipe flat, carefully remove the spiral rod, and check if it is deformed or eccentric. If any issues are found, repair it accordingly.

• Under the condition that the storage bin has material and the discharge gate is not open, it is strictly forbidden to reverse the feeder. Otherwise, it may damage the spiral blades and even burn the motor.

• If the user does not have packaging equipment from our company, it is necessary to install an overcurrent protector in the motor control section of the feeder to prevent motor burnout from excessive current, unless using our company’s recommended packaging equipment

• Perform a comprehensive inspection of the equipment every three months to check for wear, looseness, and other mechanical components.

• If the machine needs to be stopped for an extended period, it must be thoroughly cleaned, and the main power supply should be disconnected. When restarting, conduct an electrical inspection before powering on.